Jun 24, 2015 23:33
8 yrs ago
inglês term
control-calculated
inglês para português
Tecn./Engenharia
Mecânica/engenharia mecânica
Manual de tornos CNC
These fields appear on the Face Element screen:
• X END (D) or (R)—identifies the X (DIAMETER) or (RADIUS) coordinate for the ending point of the Face.
• Z END—contains the Z coordinate for the ending point. The value in this read-only field is carried over from the previous element.
• LENGTH—contains the ***control-calculated*** X-Z length of the element. This field is read-only and “CAL” appears next to it.
• ANGLE—contains the ***control-calculated*** X-Z angle from the start point to the end point, measured counterclockwise from the 3 o’clock position. This field is read-only and “CAL” appears next to it.
These fields appear on the Face Element screen:
• X END (D) or (R)—identifies the X (DIAMETER) or (RADIUS) coordinate for the ending point of the Face.
• Z END—contains the Z coordinate for the ending point. The value in this read-only field is carried over from the previous element.
• LENGTH—contains the ***control-calculated*** X-Z length of the element. This field is read-only and “CAL” appears next to it.
• ANGLE—contains the ***control-calculated*** X-Z angle from the start point to the end point, measured counterclockwise from the 3 o’clock position. This field is read-only and “CAL” appears next to it.
Proposed translations
(português)
5 | calculado pelo comando | Joao Marcelo Trovao |
3 | calculado(s) pelo controle | Júlio Pessoa |
Proposed translations
12 horas
4 KudoZ points awarded for this answer.
30 minutos
calculado(s) pelo controle
"The control calculates and enters values for X End (D), Z END, X Start (D),
and Z Start on the Chamfer Element Screen. Select PREVIOUS ELEMENT F1
to view the Chamfer Element Screen."
http://cncmanual.com/hurco-winmax-lathe-conversational-part-...
Vai depender do que você estiver usando para "control".
and Z Start on the Chamfer Element Screen. Select PREVIOUS ELEMENT F1
to view the Chamfer Element Screen."
http://cncmanual.com/hurco-winmax-lathe-conversational-part-...
Vai depender do que você estiver usando para "control".
Something went wrong...